470 mercr. water in the oil

tripbarb

Cadet
Thread starter
Joined
Jun 12, 2011
Messages
9
please help. ok i have an 83 four winns with the infamous 470 mercruiser. boat has always done great. about 3 weeks ago she run hot on me. so i changed the impeller kit new water tube etc. i noticed my elbow reservoir was low so as i filled it back up i had water running out of the raw water exhaust on both sides of leg. well i the pull the elbow it looks ok but the gasket is destroyed. so i go to my local shop and pick up a new gasket install it fill with water and it held it. thought i would check the boat out good so i put it on the muffs as i am turning it over it gets real hard to turn and i noticed it shooting water from the hose that goes from the head to the exhaust like it had a ton of pressure on it. i removed the rad cap and tried turning it over and water shot straight up in the sky and now i have water in my oil. i had none of this bfore i changed the exhaust elbow gasket. so what next?
 

guyaverage

Petty Officer 2nd Class
Joined
Aug 4, 2008
Messages
101
Re: 470 mercr. water in the oil

Before you serviced the impeller, how hot was it running?

Are you 100% sure you put the elbow gasket on correctly? Doesnt sound like it, but if so, then it sounds like you have one monster of a blown head gasket. You probably already know it doesn?t take much of an overheat to have that happen on this engine.

I would drain the crankcase asap and get the water/oil mix out of there. Also pull the plugs and check the cylinders for water, if there is any I would get that head off there soon, before the cylinders start rusting. You might get by with just new gaskets, as long as the head and block are flat and nothing is cracked. Also check the manifold and riser thoroughly for cracks/corrosion etc.
 

Desertsky

Seaman
Joined
Aug 25, 2010
Messages
73
Re: 470 mercr. water in the oil

If you are running a heat exchanger (you SHOULD be), the riser gasket should not have any water holes in it, only one for the exhaust to run through. If your gasket has holds for water flow, these can allow water to run back into the exhaust manifold, then into the engine. Mine has a stainless steel plate to block water from flowing that way. If you use raw water cooling, you remove the plate but that isn't recommended with this engine due to corrosion. Mine has the older cast iron exhaust. Yours is likely the aluminum one and is a slightly different configuration.
 

Bamaman1

Lieutenant Commander
Joined
May 15, 2011
Messages
1,895
Re: 470 mercr. water in the oil

I have a 470 engine disassembled. Once you figure out your problem, let me know if you need any parts--heat exchanger, exhaust manifold, etc. I also have a rebuilt head with zero hours, a complete engine gasket kit, a good outdrive and a 23 pitch stainless prop. I'm 170 miles downriver of you--at 256-768-0599.
 
Top