4 HP Johnson - no water flow

octog

Recruit
Thread starter
Joined
Jun 18, 2003
Messages
1
I have a 4 HP (1995 vintage - 2 cylinder) that has no water flow. Took it to mechanic and he says I have a blockage in the engine. He quoted $300 to fix. I've built car engines but never pulled an outboard apart.<br /><br />He said it might also be a grommet colapsed that I would have to remove the power head to replace.<br /><br />Are these things difficult to do? Which is best repair manual - where to get it?<br /><br />Any 'gotcha's' to watch for?<br /><br />Thanks in advance.<br />Don
 
Joined
Jun 17, 2003
Messages
23
Re: 4 HP Johnson - no water flow

If you dont have compressed air then forget it. I would personally take off the head turn the engine down spray evaporating degreaser through the <br />chambers then spray the heck out of it. Then of course clean out pathways in the head. Next I would take compressed air with a rubber tip and snug it against the water tube and spray the bejeezus out of it. Add new head gasket new impeller you should be on your merry way. I tell any enthusiast to invest in a compresser it can save you so much money! The biggest problem w/these 4's not pumping is clogging in the cooling system...consider the exhaust housing as well. I know it sounds drastic but its the truth
 

TELMANMN

Chief Petty Officer
Joined
Jun 9, 2003
Messages
465
Re: 4 HP Johnson - no water flow

Not knowing what kind of engine brand, but it is new enough as being a 1995, order a manual from the manufacturer. <br /> If as you say you are mechanically inclined, then the manufacturer's manual is the best. <br /> Being a smaller engine you should not have any difficulty taking it apart. The small cost of the manual will help your piece of mind.
 
D

DJ

Guest
Re: 4 HP Johnson - no water flow

Octog,<br /><br />There are manuals availble on this site-lower left corner of title page..<br /><br />I prefer OEM first, Seloc second.
 
Top