3hp Lightwin repair

bytal

Recruit
Thread starter
Joined
Sep 3, 2016
Messages
3
Hey guys, So I just picked up my first outboard motor project which I got sight unseen from an auction for 30 bucks. Its a old '57 Lightwin 3hp that was in pieces. Everything seems to be there. I've checked the compression and getting 75psi on each cylinder which seems good to me. My main concern though is the bottom of the block and crank has some nasty corrosion and looks like someone tried to reweld the aluminum on the block and did a terrible job of it. Does anyone have any suggestions on how to go about repairing this? I figured I could pull it apart and give the block to my friend's dad you spent 40 years as a welder and see if he can fix it up then ask one of my machinist friends to clean up the bore area where the crankshaft sits but I'm unsure what the 3 holes right next to the crankshaft are for? Can this be fixed or should I just throw the parts on Ebay?
IMAG2346.jpg
 

Attachments

  • IMAG2346.jpg
    IMAG2346.jpg
    325.3 KB · Views: 0

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Not sure what someone was trying to do there.------Lots of those motors were made and lots of used parts available.----Post an ad on ----aomci------to find parts.
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
I think I would open that one up to see if water got in.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
The circular channel around the bearing is the water outlet (It cools the bearing). So with all that corrosion, I agree with High Trim, it is very likely the water got into the crankcase and caused extreme damage. Better take a look.
 
Top