twintrades
Petty Officer 1st Class
- Joined
- May 7, 2008
- Messages
- 305
I found a 35 hp seahorse at the dump this winter. The shift indicator was broken in forward( outside lever not internal Ithink). It has good comp. But the wire harness ends in a connnector in the engine. Like it would go up to the front of the boats Dash.
What im asking is how can i hot wire it to see if it will run ? At the connector in the engine i can see the colored wires. Which should i jump to make it work? If nothing at all i would like to see or feel a spark. Oh and it has the wires running out the case for batt hookup. The neg. would be the one that connects to the engine block right?? and positive connects to the selinoid?
Lastly on the carb hood thing It says somthing about 25 hp. But the hood says 35. IN the serial is looks liek it might be a 25.???
Hear are the numbers.
Model no 25e78e
serial no E4876218
Any and all comments are welcome
What im asking is how can i hot wire it to see if it will run ? At the connector in the engine i can see the colored wires. Which should i jump to make it work? If nothing at all i would like to see or feel a spark. Oh and it has the wires running out the case for batt hookup. The neg. would be the one that connects to the engine block right?? and positive connects to the selinoid?
Lastly on the carb hood thing It says somthing about 25 hp. But the hood says 35. IN the serial is looks liek it might be a 25.???
Hear are the numbers.
Model no 25e78e
serial no E4876218
Any and all comments are welcome