Boata Fett
Cadet
Thread starter- Joined
- Jun 4, 2017
- Messages
- 7
Hello first time poster I recently purchased a 1968 glastron aqualift fish and ski I rebuilt the carb with a carb kit I purchased online and it started right up after sitting for 4 plus years, got it registered and hit the nearest lake to tune the carb ran across the lake with no issues however small 1/4 turn carb adjustments didn't seem to do anything until the high speed needle was almost closed then it starts to stall until u open it back up. After puttering around for about 5 min the motor just stalls and you have to wait about 5-10 min before attempting to restart and once restarted it seems to just go into limp mode, I doubt this is a thing but it's the closest comparison I could think of, it will run in this "limp mode" for a few min before cutting out again and then I have to repeat the process, so I got it home and put it in a tank and tried to trouble shoot it, pulled the plugs there covered in carbon, cleaned them and restarted it same thing happened went to pull the plugs and the motor and lower end seem to be hot idk if this is normal and the plugs are covered in black carbon again pulled the carb again to clean and it doesn't seem to have any excess dirt did pull a little of the old packing out of the bowl but nothing major sprayed compressed air through all the passages and they all seem clean re assembled and same thing happened any help or advise would be greatly appreciated