30hp Johnson

Scootersboat

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
4
Just signed up. I have a 30 hp Johnson that I overheated. The engine would not restart and I had smoke coming off of the back of the engine when I pulled the cover after it heated (burning rubber/plastic smell).

I am decent with engines, just minimal experience with outboards and feel dumb for overheating this one.

I thought I melted a piston or wrecked a cylinder. I had figured I had low compression as I could turn the engine easily over by hand. Once I pulled the head the bore looks fine, no scorring or signs of a melt down at all.
Could I have just failed a head gasket, I cannot really see any tell tale signs of a blow out there. The head bolts were pretty easy to loosen, is that normal?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Probably a warped head at least. Take the transfer port covers off and look at the pistons and rings see if they look good. If they look good then Resurface the head by putting 220 grit sand paper on a piece of glass. Run it in figure 8s until it is all shiny. Get a new head gasket and see what happens.
 

Scootersboat

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
4
Thanks for the response. Warped head is something I didn't consider. I will have a look in the transfers and check everything out.

If that all checks out the next issue will be finding out why it wasn't pumping water, will cross that bridge next. Impeller looks good.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
People careless with their trash have killed more than a few motors. A plastic trash bag will wrap itself right over the intakes. Bad stuff happens. Then, you slow to a stop, the bag floats free and you're none the wiser.
 

Scootersboat

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
4
People careless with their trash have killed more than a few motors. A plastic trash bag will wrap itself right over the intakes. Bad stuff happens. Then, you slow to a stop, the bag floats free and you're none the wiser.

I hear ya, this was my fault 100% for not noticing the obvious signs it wasn't pumping water through the motor. I had an issue last summer with it running hot, still pumping, and inspected the pump this year before it hit the water. When the pump checked out I did not do my due diligence to go further and look for other problems, thermstat etc.
 

Scootersboat

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
4
Probably a warped head at least. Take the transfer port covers off and look at the pistons and rings see if they look good. If they look good then Resurface the head by putting 220 grit sand paper on a piece of glass. Run it in figure 8s until it is all shiny. Get a new head gasket and see what happens.

I quickly straight edged the head this morning and it does appear to look warped.
I will hunt down a piece of glass and check the transfers today.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Don't ignore the hottest part of the engine--the exhaust side. It is almost guaranteed to leak after such an overheat. When it does, water may squirt into the exhaust ports and completely destroy the powerhead. Replace the gaskets!!
 
Top