I have a 3.0 GS that stalls when put in gear, but only when cold. It starts right up and will idle indefinitely, but stalls as soon as it's put in gear. It only happens when the engine is cold. Once it runs for 5-10 minutes, it works as expected. The typical scenario is that after launching in the morning, I have to sit on the dock while it warms up enough to pull away. 10 minutes feels like an eternity when everyone is waiting for you to get out of the way.
The choke closes after priming, and slowly opens as the temp increases as I would expect, but it's only reading 7 volts. I'm not sure if that's an issue or not. Also idle seems like it might be a bit high at 1800 RPMs, but I'm far from an expert. I could use any advice the experts here can share.
Thanks
The choke closes after priming, and slowly opens as the temp increases as I would expect, but it's only reading 7 volts. I'm not sure if that's an issue or not. Also idle seems like it might be a bit high at 1800 RPMs, but I'm far from an expert. I could use any advice the experts here can share.
Thanks