28 hp evinrude issue

jm89

Recruit
Thread starter
Joined
Apr 24, 2016
Messages
3
I have a 1987 28 hp evinrude with electric start. Just pulled the carb and rebuilt. After carb install and hooking the starter back up in tried to crank it. It melted the negative battery post off the battery. Does anyone have an idea of what could cause this. I'm pretty sure I hooked everything back up correctly.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Sounds like the positive cable is touching ground somewhere.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Wow. Two things can cause heat. A high resistance or a high current. High current of that magnitude would almost have to be a direct short circuit. The high resistance would be localized where the heat occured.

Did it actually melt the battery post, or was it the cable that melted?
 

jm89

Recruit
Thread starter
Joined
Apr 24, 2016
Messages
3
The cable was extremely hot but yes it literally melted the post out of the battery
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
I've seen that happen but something like a wrench or something had fallen across the battery and shorted it out.
 

Fed

Commander
Joined
Apr 1, 2010
Messages
2,457
Is it possible you turned the positive stud on the starter motor a little when you disconnected & reconnected it?

A dead short to ground will heat up any not so good connection, in your case the negative.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Almost has to be a dead short. If you don't know what that means, imagine if you connected the positive cable to ground on the motor (negative also connected to ground). That would be a dead short and a very high current would flow, causing much heat.
 

jm89

Recruit
Thread starter
Joined
Apr 24, 2016
Messages
3
fed that could a possiblity i did notice that the starter bolt was crooked upon reconnecting the cable. now that you mention it. it seemed to be loose... i pulled the bolt back out, landed the positive cable and tightened the nut.
 

Fed

Commander
Joined
Apr 1, 2010
Messages
2,457
Check the BRP website ( shop.evinrude.com ), drill down to your exact motor and check the starter motor drawing.

You will see that item #s 14 and 15 are insulated to stop any part of item # 12 from touching ground.

From what you have described I think you should look inside & make sure it's all in the correct position & locked up tight with the first on nut # 18.
 
Top