25hp Johnson...what gives?!?!

Nytro640

Recruit
Thread starter
Joined
Apr 21, 2016
Messages
5
Hello everyone,
Did a compression test, had spark, no water in lower unit etc...so I bought it. That's correct, I haven't used it yet. I cleaned it up and was eyeing up this brass fitting on the cylinder head. Seemed odd but didn't think much of it. So I get the hose out and spark it up. Well what the!!!! There's water shooting out of it about as far as its shooting out from the impeller. I believe the microfiche is calling it a pressure tap? Looks like nipple that a house should be attached to. What's the deal?!?! Thanks!
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Sorry, I don't know the answer to your question. But for whatever it is worth, it is a 1999 model.
 

Grub54891

Admiral
Joined
Jun 17, 2012
Messages
6,494
Probably just as it says, a pressure tap. A hose would hook to it and run to a gauge on the dash. It tells ya how much pressure the impeller is putting to the motor, thus letting you know if the impeller is failing or debris is clogging up the water pickups.
 

Nytro640

Recruit
Thread starter
Joined
Apr 21, 2016
Messages
5
Well it's a tiller, one can tell it had controls at one point. So I can simply cap it off?
 

Grub54891

Admiral
Joined
Jun 17, 2012
Messages
6,494
Yup, as long its not the tell tale, it don't sound like it is. Just get a cap from your local parts store, they sell kits with various sizes. add a small zip tie to make sure it stays in place.
 

Grub54891

Admiral
Joined
Jun 17, 2012
Messages
6,494
The tell tale is the one that spits out water when the motor is running, down under the cowl. If its not, it could be plugged with mud dabbers or the fitting you have is supposed to have it hooked to it.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Just looked at a 99 35 hp model 3 cylinder.---------Has an empty hole where a temperature sending unit can be installed.--Across from that is a pipe plug where a fitting can be installed for a water pressure gauge.--------Sounds like you need to install a pipe plug or a water pressure gauge.
 

Nytro640

Recruit
Thread starter
Joined
Apr 21, 2016
Messages
5
I just picked up a brass plug from the shop by work and plugged it. Thanks everyone, cool site.
 

60sboater

Petty Officer 1st Class
Joined
Jun 18, 2015
Messages
307
How's it run? I have a '72 25hp purchased from CL for only $225...needs some work but runs fairly well.
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The original poster has a 3 cylinder 25 hp motor.----It is a very rugged and heavy motor.----Totally different from the light weight 72 model 2 cylinder motor.
 
Top