200hp Evinrude H.O.

NBsmallmouth

Recruit
Thread starter
Joined
May 21, 2018
Messages
2
I have a 2006 Evinrude 200hp H.O. on a 99 javelin renegade 20. I get 54mph @ 5100rpm wot. I' trying to research whether I should change my prop or raise my motor or possibly both to achieve full rpm rating and top speed. From what I found about 5900rpm would be my top end. The boat has a bit of a slow hole shot.
my current prop is a RAKER 2 , 14 1/2 x 26 and I do have a manual jackplate so could lift the motors little higher. This is my first boat. Any insight/advice would be greatly appreciated. TIA
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
Single or dual console? That hull should be a High 65+MPH if set up correctly. Need to check the motor compression and 2006 should be a DI motor....
 

NBsmallmouth

Recruit
Thread starter
Joined
May 21, 2018
Messages
2
It' a single console. I raisedbthw jackplate to it' max. I' not at 60mph, 5250rpms @ wot.
The local boat shop tells me I need to be running a 26 pitch which I have now. It does have a couple small dings. Dealer just ordered in a 14 1/2 by 26 RAKER H.O. for me to try out. Engine is mint. Zero codes on it and properly maintained. Appreciate the replies.
 
Top