2002 Johnson 9.9

Kyoungblood

Recruit
Thread starter
Joined
Jun 24, 2018
Messages
5
Have a johnson never had any trouble with the little motor. But put a new water pump in and now am having a very hard time putting it in forward gear and it is making a awful noise like a bad humming need some help if anyone can help me with the shift road measurement for this motor I can't find anything. Thanks in advance for any help
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
When you remove the lower unit you need to REMOVE one screw from the coupler.--------Shift rod is screwed all the way in and backed out if need be to make angle point forward.-----You have to make absolutely sure that the notch on lower shift rod lines up with the hole before you install the screw.
 

Kyoungblood

Recruit
Thread starter
Joined
Jun 24, 2018
Messages
5
So I need to screw it all the way in the lower unit and only adjust it out to make sure it's lined back up at the upper coupling on shift rod correct ?
 

thatone123

Banned
Joined
Mar 7, 2009
Messages
707
Those couplers are the pain in the # on OMC...Jap motors and others solved that with better ways to do it! Needle nose pliars help a lot and a headlamp if not outside. Yes, that notch must be all the way in. Do not take out both screws as it is double the pain to get both back in properly...This job is one that gets easier the more times you do it and no one can argue with that.
 

Kyoungblood

Recruit
Thread starter
Joined
Jun 24, 2018
Messages
5
Ended up being the lower unit as we thought got it tore down now was just grasping at a easy fix I guess thanks for all the help guys
 
Top