2001 Johnson 150 speedometer problem & rudder problem

stevenburkhart

Recruit
Thread starter
Joined
May 18, 2003
Messages
4
I am running a 2001 Johnson (OMC) 150 HP, V-6 motor. On my maiden voyage, I hit a large piece of wood at full throttle (60 MPH). This knocked my speedometer out. Upon inspection, I noticed a little rectangular piece with holes in it at the bottom of the lower unit that was damaged. This part is permanently connected to some sort of numerically gauged adjustment housing that is best described as a round "sundial". Is there a part number for this?<br /><br />Also, when removing the boat at the ramp, I accidentally dragged my rudder on the concrete and broke off the tip (1-1/2" long), after trying to bend it straight. Now the boat pulls to the right above 30 MPH and is hard to steer to the left. Will I need to replace the entire lower end, or can I just get the housing? <br /><br /> :rolleyes:
 
D

DJ

Guest
Re: 2001 Johnson 150 speedometer problem & rudder problem

The part hanging down (sundial) is your trim tab. That is a seperate part and can be replaced as such.<br /><br />If your skeg is that bent, a new housing is probably in order. Especially at the speeds your rig is capable of.
 

stevenburkhart

Recruit
Thread starter
Joined
May 18, 2003
Messages
4
Re: 2001 Johnson 150 speedometer problem & rudder problem

Thank you for your advice. The trim is working fine, so I'll probably leave the trim-tab alone. With the housing, can I cannibalize an older non-working lower end? Also, would you advise me to do it myself (assuming I'm mechanically inclined) or have a professional do it?<br /><br />Any mention of the speedometer?
 
Top