2001 evinrude 50 hp four stroke idle problem

Mike pruden

Recruit
Thread starter
Joined
Apr 16, 2017
Messages
2
Inherited boat with this motor replaced high pressure fuel pump. Runs fine in gear, but cannot get idle to adjust to 800 rpm. Tried adjust of air idle screw (as per manual). Runs at 2200 rpm in neutral. Any suggestions on what to do next. Runs at approx 5mph in gear, with no throttle.
 

daselbee

Commander
Joined
Jan 20, 2009
Messages
2,765
Sounds like the throttle butterfly is slightly open. Butterfly must be closed at idle. All idle air is metered by the idle air solenoid and the screw you referenced.
Also, that screw doesn't really adjust idle speed, it is a fine adjustment to bring the duty cycle of the idle air solenoid to spec. I think I remember that spec be 25% duty cycle. That figure must be set with the software.
 

Mike pruden

Recruit
Thread starter
Joined
Apr 16, 2017
Messages
2
Sounds like a trip,to the dealer to set up the software. Could it be a sticky butterfly valve? Boat sat for a couple of years, maybe a shot of carb cleaner on the butterfly?
 

daselbee

Commander
Joined
Jan 20, 2009
Messages
2,765
You could try it. I for sure would visually look down it's throat. You can also pop the linkage loose from the top of the throttle body. If it is just misadjusted, that will allow the butterfly to pop closed. Visually watch carefully to see if you can detect any movement showing that it is indeed open a little bit.

You will be very lucky to find an Evinrude dealer that will look at it. If all else fails, try a Suzuki dealer. Engine was made by Suzuki.
 
Top