170 hrs... I've got the software...no current codes...no check engine light
last week started running missing and would stall when going into gear, installed and indexed new plugs...cleaned intake and cylinders with Sea Foam...hooked it up to hose at house, idled smooth and went into gear as it should...got on the water this week and started running rough and when I got to 4000 rpm it feels as if I hit a rev limiter...tried several times to go fast past 4k and then just bump it past 4k... same results...feels like the ignition shuts off at 4k, doesn't stall the motor just no further acceleration...ok so I got back home and pulled the plugs again all looked as I expected...black with some soot but not wet, except for #2 and it was ash tan...looks like it was running lean to me...I was thinking TPS but I think that I would be getting a code with that...the EMM has to shutting the engine down to protect itself at 4k I just now sure what sensors would create such a signal... Please help....thanks...tim
last week started running missing and would stall when going into gear, installed and indexed new plugs...cleaned intake and cylinders with Sea Foam...hooked it up to hose at house, idled smooth and went into gear as it should...got on the water this week and started running rough and when I got to 4000 rpm it feels as if I hit a rev limiter...tried several times to go fast past 4k and then just bump it past 4k... same results...feels like the ignition shuts off at 4k, doesn't stall the motor just no further acceleration...ok so I got back home and pulled the plugs again all looked as I expected...black with some soot but not wet, except for #2 and it was ash tan...looks like it was running lean to me...I was thinking TPS but I think that I would be getting a code with that...the EMM has to shutting the engine down to protect itself at 4k I just now sure what sensors would create such a signal... Please help....thanks...tim