200 Venom backfire between carb and reed

BrannonB

Recruit
Thread starter
Joined
Mar 26, 2017
Messages
3
Hello all, new to the forum but have been seeking advice for years on this forum. Let me give you a quick rundown of what happened and what I have tried so far.

March 2016: Was running down lake and felt like I hit some trash such as a small limb or something but I didn't actually hit anything. It was just a small jolt and the engine started to sound a little weird. Continued on since I was headed to the ramp anyway. I stopped a little short to check on things and boat was running like a plug wire had came off but all was good. It would not come up to plane. Idles good, starts good and revs good.

Fast forward to present day. I have changed plugs, checked fire, cleaned carbs and throttle plate, clean gas, checked vacuum and fuel lines, changed fuel filter.

While running the boat on the hose I noticed when I blip the throttle there is backfire between the reeds and carb on number 5. No other carb does this.

Now a little history on the motor.

It's a 98 venom 200 block, the block has been bored, the intake and exhaust ports have been modified, it has 225 carbs on it, airbox has been modified because of port work and carbs the air box was too restrictive to supply enough air to motor. New coils, new power pack, heads have been shave, high compression so I run 93 gas, carbs are set a little rich just as a safeguard and timming has been bumped up so it's not as hard on pistons.

I have a video I can post on YouTube and link to here if needed or I can email.

Thank you
Brannon.
 

BrannonB

Recruit
Thread starter
Joined
Mar 26, 2017
Messages
3
That was the plan for this past weekend but I left my compression tester and timing light at work. I want to make sure all are firing in the correct order. I would also like to add that this motor only has about 40-50 hours on it from last build that was in 2014.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Putting your finger over spark plug hole 5 might tell you something without need for the tester, might of being running lean and pow/bang. If its still compressing id be pulling that carb off and checking for a blockage before it did go bang due to bearing failure etc.
Id also be moving its piston to tdc and checking for big end play with a screwdriver with a bit of cloth around it poked down the spark plug hole
 

BrannonB

Recruit
Thread starter
Joined
Mar 26, 2017
Messages
3
We actually did that Sunday just testing compression. My dad put his thumb over the hole and I turned it over and it's got pressure. I'll know more when I get the gauge hooked up to it.
 
Top