Tanderson4
Recruit
- Joined
- May 16, 2020
- Messages
- 5
Hey everyone, this is my first post and am a new to boat wiring. I would appreciate any help if possible. I have a 1986 bayliner trophy with a force 125 outboard. I am replacing the old tilt trim motor with a new DB electrical one. The old wires and single relay from the previous motor (3 wires) are still connected to the tilt trim switch on my panel. Can I somehow use the existing wires to connect the new motor which is only 2 wires? Or would it be best to run all new wires and relays from the switch to the motor?