2 stroke fires but won’t start HELP

Jack2121

Recruit
Thread starter
Joined
Jun 9, 2018
Messages
3
Alright so I have an outboard 88hp 1990 2 stroke Johnson engine that fires but won’t start. It will do a 3 or 4 putts and dies out immediately. Carbs have been checked and rebuilt, good compression, new plugs and good spark, timing is good, kill switch seems to be ok, new fuel, fuel pump is good, solenoid is good primer is good and battery is good. I am running out of ideas. Please help!!
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,328
Spray some mixed fuel into the carbs and see if she will run a few seconds. If so, either the choke (enrichener) is not working properly, or the carb idle passages are clogged or the carb mixture is out of adjustment.

Johnny's of that vintage can have a particular initial carb mixture setting. What did you use?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There is no mixture adjustment feature on that motor ?-----
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Perhaps check the flywheel key , timing may be off.----Take starter apart for inspection too.----When did this problem show up ?---How long have you had the motor ?---You are advancing throttle on cold starting I hope.
 

Jack2121

Recruit
Thread starter
Joined
Jun 9, 2018
Messages
3
They fly wheel key is good. I’ve had the motor for about 5 years and haven’t had any issues. It stopped working towards end of last summer but put it away for the winter. She fires but can’t get it going. I use 50:1 ratio for the fuel which is what this engine takes. I’ve tried giving it throttle to cold start and without. She’ll only fire for less than a second when I don’t give throttle and nothing if I do. Thanks everyone for the replies
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
All indications are that your motor should start with the turn of the key.--But it is not !------So with the sparkplugs in the cylinder heads do you have spark that will jump a gap of 7/16" or more , yes or no ?----What are the actual compression numbers today ?
 

Jack2121

Recruit
Thread starter
Joined
Jun 9, 2018
Messages
3
Compression is 120 in 3 and 1 at 90. I know it should not be at 90 but that shouldn’t be the reason it won’t start. There is good spark. I’m not sure if the jump distance since someone tested it but I was told it has good spark and I replaced the plugs.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
All indications posted at the start of this thread indicate that your motor should start right up.----But it is not.----You need to do a maximum ignition output test when cranking with the sparkplugs in !----Does the spark jump a gap of 7/16" or more then .---Are the wires going to the top coils orange with a blue stripe ?------You might want to remove the bypass cover for the cylinder with 90 psi compression, just 6 wee bolts and a cheap gasket.----Look at the piston and rings.---You may not like what you see there.----Testing , inspection and trouble shooting needs to be done here.-------Your motor is not starting and I think it should be easy to figure out.
 
Top