2.5L OMC Seadrive fuel issue

JohnL0378

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
12
I have a 6 cyl seadrive. When it sits an idles it is fine but when I go to give it throttle it dies. I took apart the fuel pump and everything seems to be ok. The VRO is unhooked but the wires were not. Would this cause my issue? I have already checked for plugged lines and found the pick up tube from tank was plugged by the screen. I have changed my priming bulb. And now it leads me here. I am out of ideas. Next step is to put an electric fuel pump on if I cant get it figured out.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The wires are for the alarm and have nothing to do with your issue.---------Step # 1 is to do a compression test on that motor !-----Then check for strong spark on each lead.
 

JohnL0378

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
12
Compression test has been done recently. It runs fine and fires right. So what you are saying is the 4 wire harness is just for the alarm.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The VRO is run by crankcase pressure pulses and not an electric motor.---The wires are for alarm set-up.---Maybe check the flywheel key.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Those symptoms don't lead to a faulty fuel pump. Try squeezing the primer bulb as it dies, also push the key in as it dies.
 

JohnL0378

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
12
OK update. I check crankcase pressure and I have plenty of pressure coming out. Is there anyway to bench test the pump?
 

JohnL0378

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
12
I pulled hose off of fuel pump while someone cranked motor over and there was a significant amount of air coming out.
 

Auxlarry

Petty Officer 1st Class
Joined
May 21, 2010
Messages
304
I've been running the 1.6L Sea Drives for 25 years and have had some similar problems. Since it still has the VRO, what is the output fuel pressure? I pulled my VRO and went to the standard fuel pump years ago, yours would convert over to twin fuel pumps which is an eash switch if you need to do so! Have the carbs been rebuilt lately? When was the last time you changed the main fuel hose through the engine mount bracket? I chased a problem once that led me to the fuel line being pinched in the bracket assembly. I change the fuel and oil hoses through the bracket about every 3 years since they go through a lot of flex and are exposed to direct salt water on my boat. If the hose starts to get hard it will crack at the top bend of the bracket assy.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Why don't we start with a model number and open air gap spark check and compression check. After that you may want to do the fuel restriction issue by plumbing in 4 " clear 3/8 hose and a vacuum Guage just after the cowl connector. Report inces/hg and presence off any air bubbles. Report 7/16 spark results. Report compression values. Report model number.
 

Fed

Commander
Joined
Apr 1, 2010
Messages
2,457
If it idles fine then the carb bowls will be full of fuel and it should not die when you start to give it some throttle.
Different if you were going 100 Yards then dying.

I'd forget the fuel pump and start thinking blocked intermediate jets or link & sync.
 

Auxlarry

Petty Officer 1st Class
Joined
May 21, 2010
Messages
304
Might be a trigger assembly as well. I had this symptom once where it would run at idle but as soon as I tried to increase the power it would just die. Would restart fine but only run on idle. It was a slow 3 knot 2 hour trip back to the boat ramp....lol
 

JohnL0378

Cadet
Thread starter
Joined
Mar 1, 2016
Messages
12
I have done a compression test and I am getting 90 on all cylinders which according to the book is low. But I went and talked to a local mechanic and he said that that is actually ok and to get amy thing higher I would be lucky. We believe we have it narrowed down to either the fuel pump or the power pack. Talking it out today to do one more test to rule out the fuel pump
 
Top