1999 Johnson v6 200hp tach issue

misterfixitterry

Recruit
Thread starter
Joined
Jun 3, 2014
Messages
3
I bought a 1999 200hp v6 outboard last summer and the tach has never worked. the shop took a quick look at it last year and said the part that feeds the tach signal needed to be replaced. what part on my outboard feeds the tach? is it the rectifier? just looking to shop for the part in the off season so I am prepared for summer. Thanks guys.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
There's a couple of parts so go back to the shop and ask them.
 

misterfixitterry

Recruit
Thread starter
Joined
Jun 3, 2014
Messages
3
regulator/rectifier? does that sound right? Is that one part on this outboard? Sorry for the dumb questions, im a noob at outboards and unfortunately the shop i bought this motor from is a couple hours away and I dont want to pull the boat back. They said they would sell me the part at cost so im just trying to figure out if that is cheaper than me shopping around for a used part. Thank you.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,335
I would expect your motor to have the water cooled voltage regulator mounted on top of the block, behind the flywheel, under a plastic cover. The grey wire provides an AC-like signal to the tach to allow it to read the RPM of the motor. I would first make sure the wire from the tach to the VR is good, and not grounded anywhere. Secondly, make sure the tach has +12VDC and ground to it as well.

That VR will be $300+ to replace, so make sure it is bad first.
 

misterfixitterry

Recruit
Thread starter
Joined
Jun 3, 2014
Messages
3
ok, so i should be able to hook an electrical tester up to the grey wire, as close as feasible to the regulator, ground the other lead on the tester to the block somewhere and read an ac output when running? correct? thank you.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,335
That is correct. I am not sure what the AC voltage will be, so start on a high scale. You could also tap into the stator output before it enters the VR as well.
 
Top