1999 johnson 50hp 2cyl rebuild

Meyert

Recruit
Thread starter
Joined
Sep 3, 2017
Messages
3
Hey guys brand new to the forum. I have done a little work on 2 other johnson erudes before. I have one now that I am working on. It's a 1999 johnson 50 2 cylinder. I bought it for 300 bucks from a Guy that said he knew nothing except it's not running. I dropped the lower unit and spun the shaft with it in gear and the prop turned, the shifted it into reverse and it turned the other way. I pulled the spark plugs out and turned the flywheel. As the bottom piston came up it pushed a bunch of thick brown sludge to top of the chamber. So I thought ok blown head gasket and water getting into the cylinder. I pulled the head off and the bottom cylinder is covered in thick brown sludge with chunky particles in it. I can't find any cracks or gouged in the walls. No cracks or wholes on the top of the piston either. There is also no indication that the head gasket was blown. I'm beginning to think the motor was just sunk while running and pulled water into the cylinders through the carbs and breather. I have pics to post. My question is would you guys keep tearing it down at this point or just clean it up and put it back together with new gaskets? Also what would be the best way to clean up the cylinders, head, and piston tops.? Lastly is there anyplace else I should look to try to find where the water is coming in before putting back together?
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
Tear it down and inspect crank,rods and wrist pin for rusting and pitting, if found its a parts motor.
 
Top