1999 90 hp johnson

reconpi

Recruit
Thread starter
Joined
May 21, 2011
Messages
3
My 1999 johnson 90 hp outboard motor when starting runs the battery down after about 7 or 8 attempts. even if I use a "jump starter" it makes no difference the motor still won't turn over strong enough to start.. The starter gets hot to the touch..The dual batteries are new and on a selector switch.
 
D

DJ

Guest
Re: 1999 90 hp johnson

1. Disconnect the battery.

2. Remove the negative battery terminal form the engine block and clean thoroughly.

3. Reconnect and reconnect battery.​
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Re: 1999 90 hp johnson

That starter consumes a lot of amperage during starting. It will get hot, if repeatedly cranked for more that 10 or 15 seconds.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: 1999 90 hp johnson

It obviously should crank longer than that on a fresh battery. Either the starter has a short, or the battery cables are corroded.

Use jumper cables from battery directly to starter casing(negative) and starter positive post. If the result is the sme, you might get starter tested for shorts.
 

hipshot007

Cadet
Joined
May 3, 2011
Messages
17
Re: 1999 90 hp johnson

I have a 1990 90 hp doing the same thing,first do you have spark. mine dosent and carbs get over loaded with fuel ,I think to much in cylinders cant compress so it starts over loading batteries.My thought anyway luck to you
 

reconpi

Recruit
Thread starter
Joined
May 21, 2011
Messages
3
Re: 1999 90 hp johnson

I cleaned off the contacts at the starter and battery and all I get is a quick "clunk" when engaging the key. After doing this several times the motor will start. The engine never "spins" it just gives a quick clunk. Even if I leave the key engaged it won't spin. Which wires do I jump to from the battery. The "ground" on the block and the one on the starter or the one on the "solenoid" The batteries are new and charged.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: 1999 90 hp johnson

I previously recommended you jumper directly from the battery to the starter, thereby isolating the starter from the balance of the wiring and solenoid. If the starter spins the motor, it is probably good. The connections between the battery, the ign switch a dn the starter solenoid, and including ground are the likely causes for low battery voltage/current in the starting circuit.
 
Top