1999 25hp johnson oil inector problem

roger1950

Recruit
Thread starter
Joined
Apr 23, 2012
Messages
4
I have a 1999 Johnson outboard engine with constant ratio oil injection. After sitting for the winter, the other day i went out and unhooked the fitting from the fuel tank to the engine to use it on another motor. Upon returning to my engine later, i notice fuel and oil mixture on the foot of the engine. Taking the cover off, the oil injector tank was full. Fuel had ran back into the tank and overflowed. What could cause this to happen?
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 1999 25hp johnson oil inector problem

This was a known problem on those mtrs. Remove the oil tank and the injecter and plumb the fuel pumps directly to the carbs. Then mix your fuel 50:1. If you don't do that you could end up with 3 scored cyl's as it's happened to me. A lot of times the oil tank would end up with straight fuel in it. That system Sucked !!
 

roger1950

Recruit
Thread starter
Joined
Apr 23, 2012
Messages
4
Re: 1999 25hp johnson oil inector problem

Thanks for the reply. I was going to leave it with the oil injector, but after this incident I would always be thinking about it. Just to make sure, all I need to do is take the inlet fuel line and the outlet fuel lines from the bottom of the oil tank and connect them together, or run a solid line, and disconnect the wiring harness from the top of the oil tank and tape them? i have a 15 HP Evinrude i have mixed fuel for 30 years and it never gave me a problem. so i think mixing is the answer.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 1999 25hp johnson oil inector problem

You have the procedure for disconnecting the oil tank correct. Then remove it from the mtr and throw it as far as you can.
 
Top