rjcamel2355
Petty Officer 1st Class
- Joined
- Apr 22, 2015
- Messages
- 221
Hey guys, I have two 1999 Ficht 200HP complete motors. One has a bad injector on #4 and the cylinder is also bad. The other motor the computer went out, but still has 120PSI on each cylinder.
Is it just a simple swap the powerhead onto the midsection on the boat, swap the good computer onto the block with 120PSI, and it's good to go. Or is there something else that is going to need to be done?
Just the typical powerhead removal I assume?
Is it just a simple swap the powerhead onto the midsection on the boat, swap the good computer onto the block with 120PSI, and it's good to go. Or is there something else that is going to need to be done?
Just the typical powerhead removal I assume?