1997 Force 15 hp Loose in pivot shaft

[pecheux]

Good day, Last fishing trip I thightened the adjustement screw so the motor would remain straight while trolling but the engine kept on going to one side. (it idles rough)

When out of the water I checked and noticed there is a bit of loose in the pivot shaft. I see no other user's ajustement but a screw for that purpose. Is there anything else I can tighten to eliminate that loose ?

What I describe as pivot shaft (not finding better) is the shaft on the engine (male part) that holds it to the transom part (female part)

Thank you all, and have a great day.

 

[roscoe]

Re: 1997 Force 15 hp Loose in pivot shaft

See the diagram in the link below, parts 9-10-11-12 ??

http://www.mercruiserparts.com/images/FORCE/809717/12.png


Perhaps #9 needs to be replaced, cleaned, or shimmed with ?? adhesive backed rubber ?? to provide a bit more friction.

 

[pecheux]

Re: 1997 Force 15 hp Loose in pivot shaft

See the diagram in the link below, parts 9-10-11-12 ??

http://www.mercruiserparts.com/images/FORCE/809717/12.png


Perhaps #9 needs to be replaced, cleaned, or shimmed with ?? adhesive backed rubber ?? to provide a bit more friction.

Thank you ... this diagram will help Have a great day.

 

[pecheux]

Re: 1997 Force 15 hp Loose in pivot shaft

Fairly old tread ... but since it's winter months here, it may also be the best time for a fixing.

The ajustement screw is tightened as much as possible but no longer puts enough pressure on the plate(s) to keep the engine straight while trolling, but shows no loose.

I presume there was either a lack of grease lub in the whole pivot unit that caused premature wear on the pressure plate itself due to the fact that this motor shakes at idle which is 90% of it's usage.

Question: Is this problem an issue with this model OB ? So I know if it's worth fixing, or if I have to put up with a pressureless pivot. And how big of a job to change em ?

Tx