1997 Evinrude stalling

porter

Recruit
Thread starter
Joined
Jun 15, 2003
Messages
2
I have an intermitent problem. Mechanic says I could spend a lot of money and trips finding it. <br /><br />The engine is a Evinrude 105 jet power. Model number of the engine starts with E150. The first time leaving from the dock during the day it starts right off and won't stall. I normally anchor for a couple of hours then go again. When I try to start the engine after sitting it seems to fire up fine but won't idle. I have tried to pump the bulb or not pump the bulb. Same result. The controls won't let me start with throttle on but I think thats what it needs. If I can get the throttle on before it dies it runs beautiful. Its only a problem if it sits for an hour or so. It Will start fine if only shut down for 15 minutes or so.<br /><br />Any ideas?
 

porter

Recruit
Thread starter
Joined
Jun 15, 2003
Messages
2
Re: 1997 Evinrude stalling

Nobody replied but if someone else has the problem hope this helps. The problem got worse until the boat no longer ran. It seems to have been the primer bulb. I replaced it and it runs good. I do notice that the bulb doesn't stay firm for very long after shutting down the engine. The fuel lines all look to be in like new condition. What would cause the fuel to drain back into the tank?
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 1997 Evinrude stalling

You need to install an anti syphon valve fuel fitting on tank with the appropriate fuel line adapter.
 
Top