1997 evinrude high rpm issue slipping (help please)

rfwj

Cadet
Thread starter
Joined
Nov 19, 2007
Messages
20
Well I thought I had either a trim issue or a prop issue. Basically I run at full and it seems like I am trimmed up too high. Higher pitch to motor like trimmed too high.
I also have a odd small rooster tail following now that would not be there if trimmed all the way down. Still my trim is working and it appears that the motor is all the way down. (both short pegs go all the way in). Then I replaced the prop since it was old and I thought the hub may be bad. That seemed to make it worse?

Anyway, can the lower unit just start slipping. It is almost like when a clutch goes bad it a car. you go up a hill and it slips and the rpms go up. full speed and it slips?

Sorry for the ramble but I need some ideas to check.

thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Check the oil in the lower unit for metal bits.------Not a clutch dog problem-----Not the same as a clutch in a car !------What is the model # of your motor .---And post the measurement of the transom height.-----Top to the bottom of the boat.-----It is possible that the motor is mounted too high.
 

rfwj

Cadet
Thread starter
Joined
Nov 19, 2007
Messages
20
Thanks. I have had the boat for 15 years so I think the motor has not moved. I have read that the anti cavitation plate could have something to do with it. Can that move over time?

I am on the road so I can't get the number.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
First post does not mention 15 years.-----What else was left out in post #1 ??----Post the measurement of the transom.
 
Top