1997 150hp ocean runner surges

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
Hi all new to Iboats, got a 1997 carbureted 150hp ocean runner that is surging at about 4500 rpm have to retard throttle for it to stop once it does I can bring it back up to about 4200 rpm and it runs smooth as silk. Changed the vro pump, cleaned and overhauled the carbs changed fuel lines and filters and so forth. Checked vacum switch works plugs new. I'm stumped!!
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Did you do the throttle bodies when you did the carbs? Have you checked fuel line in/Hg and looked for air into system? Have you checked the lid of the VST for leaks, the o-ring seal goes bad. Have you tried running in the dark with the hood off to rule out air flow? (In the dark if its optical ignition, can't remember) Did you reassemble throttle linkages correctly when reinstalling carbs/throttle bodies? Model # may help.
 

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
Didn't take off the throttle bodies just cleaned carbs. I did take off the fuel distribution manifold I may go back in that and see if there is something I missed there? What is the VST?
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
The VST is the Vapor seperator. Its on a bracket front and close to center behind the air silencer. Sometimes you can have an issue with these.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
What do you mean by " surging "----and how much is it increasing in RPM ?--Could it be cavitation / prop problems ?
 

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
once I bring the boat on plane, it comes up real quick, I can bring the throttle up to right at 4000rpm runs great. As long as I hold it there. Al the way to 4200 rpm, engine runs smooth, no problems it's she. I push the throttle past 4500 rpm power will start to drop rpm starts to drop and then it will begin a cycle of power loss then it will pick back then loss the. Gain. I can retard the throttle recover and slowly advance back to 4000 rpm and smooth it out again. Prop issue don't think so because rpm is not spiking. RPM is dropping
 

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
Maybe surging is the incorrect description. Once the oscillations start rpm will only go up to where it should be per throttle setting it's not over speeding.
 

reiddo1

Petty Officer 2nd Class
Joined
Jan 17, 2012
Messages
166
Sounds like it is dropping out on a plug above 4200; are these new plugs? Is the surging cycle frequency fairly uniform above 4200 or merely sporadic?
 

reiddo1

Petty Officer 2nd Class
Joined
Jan 17, 2012
Messages
166
Sorry just saw that the plugs are new. If her cycling/surging above 4200 is uniform it just might be a fuel restriction. I think I would try racerone's suggestion first.
 

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
The oscillations are not uniform as for fuel restriction everything is new to the vro pump including the pump I think I will open up the VST and clean it out
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Fuel restrictictions are not uniform. The tank and fuel line are new? If not run on a known good tank and external 3/8" line to rule out. After, squeeze bulb with air silencer off, look for leaks. After that plumb a length of clear vinyl hose onto the the fuel in of the VRO. Tee a vacuum guage into this. Look for air bubbles and less than 4 in/Hg on the gauge.

Remember that the VST also has its own little diaphram pump.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Also, was surging the issue that led you to replace the VRO and clean carbs and whatnot? Or, did this issue develop after the work you performed.
 

Mharms

Cadet
Thread starter
Joined
Nov 8, 2015
Messages
7
Hard to tell I tried running the boat earlier is summer and got a no oil indication so changed vro pump. Once I changed that got a chkeng light suspected fuel restriction changed all hoses from tank to motor even added a fuel filter all is new. I will dove back into VST and check to make sure everything is right there
 
Top