TWesenberg
Recruit
- Joined
- Jul 26, 2021
- Messages
- 2
I rebuilt engine all electrical new, stator, trigger, regulator,hi rev module, 4 CDM's
Wire harness at motor, spark plugs,.
Rebuilt carbs, new reeds, new battery & cables. First time after installed and rebuilt it ran about 30 seconds. After al new electrical components it started right up and ran for about 3-4 minutes then stopped. Now it wont start i hooked up 2 batteries, 1800 cca. Turns over now but wont fire. Now in service manual it does not specify possion of stator and trigger, could these be in the wrong position? I will take any help i can get.
Wire harness at motor, spark plugs,.
Rebuilt carbs, new reeds, new battery & cables. First time after installed and rebuilt it ran about 30 seconds. After al new electrical components it started right up and ran for about 3-4 minutes then stopped. Now it wont start i hooked up 2 batteries, 1800 cca. Turns over now but wont fire. Now in service manual it does not specify possion of stator and trigger, could these be in the wrong position? I will take any help i can get.