1996 fast strike 150

1978 ranger danger

Recruit
Thread starter
Joined
Apr 2, 2017
Messages
4
I have a 17' 1978 178v ranger with a 1996 150 fast strike and it has a 14 1/4 ?23 prop.." I'm guessing stock prop" and the motor runs perfectly but I can only get it too turn 4900 rpm's 5 downhill "joke" with a half of a tank and my wife who only weighs 130 any advice as to if I need to get a different prop to turn more rpm but max speed on GPS is 54 have been told the boat should run 65-70 no jack plate btw thanks in advance
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
A 23" Pitch prop is likely too tall. A 21P prop will add at least 400RPM, and may get you more into the power band, which could add more RPM.

The max speed will be found at max trim, on a hull that will trim well. You want the bow and as much of the boat out of the water as possible. I would assume a bass boat would trim well, but you know what assume means....
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
hey Fazt is probably saying nobody is doing 70 mph in that set up......but it is a short boat for 150 hp!!.......it should haul.... those hulls must be something..i run a 150 on my 2070 mod V with a jack plate and I can only get into the high 40's... and my boat hull only weighs about 1200 lbs.... if you think the motor is running good...ie, great compression, firing on all cylinders....ect..... then for sure your first step is to take two more props out to the water.... id bring a 19, along with the 21, while your at it...SS...you should be running 5600 even 5800......your boat maybe full of soaking wet foam.....happened to me.....boat weighs about 500 lbs more than it should have... I cut a perfect 1 square foot of foam out of my boat and it weighed 17 lbs!!!...it should have only weighed about 2 lbs!!!...soaking wet!
 
Top