1996 evinrude 50hp. Never ending overheat alarm issue.

Forton31

Recruit
Thread starter
Joined
Apr 18, 2016
Messages
4
I have a1996 evinrude 50 hp e50tleds that keeps giving an overheat alarm and going into slowmode when it is not actually overheating. I replaced the powerpack, coil pack, thermostat, temp sensor, plugs and wired and rebuilt the water pump and it is still doing it. It is a very faint chirpy alarm that only goes off at a certain point on the throttle and will engage slow mode but even after shutting down and restarting it isnt resetting. I unplugged the temp sensor and ran it and it wouldnt go into slow mode but it still sounded the alarm. What else could it be?
 

cmorris69

Recruit
Joined
Aug 17, 2015
Messages
2
Here is a cut-and-paste from a CDI Troubleshooting Guide for Johnson-Evinrude equipment which may help:

Engines with S.L.O.W. Features: If the customer is complaining that the engine won’t rev up and shakes real bad,
the S.L.O.W. function could be activating. If the engine is NOT overheating, a temperature sensor or VRO sensor
failing early can cause this problem. Disconnect the TAN wires at the power pack and retest. If the engine performs
normally, reconnect the tan wires one at a time until the problem recurs, then replace the last sensor you connected.
Make sure that all of the TAN wires are located as far as possible from the spark plug wires. Also check the
blocking diode in the engine harness.
 

James R

Commander
Joined
Feb 1, 2007
Messages
2,681
Sounds like the blocking diode is faulty. This is usually taped in amongst the harness wires so to expose it for testing it is necessary to cut through the wrapping electrical tape. A 1N4007 diode from Radio Shack will replace it.
 

Desertsky

Seaman
Joined
Aug 25, 2010
Messages
73
Also check for grounded thermostat wiring. Look for areas where they go around sharp edges, etc.
 
Top