1995 Johnson 48 wierd

Arachnid

Recruit
Thread starter
Joined
Aug 13, 2003
Messages
3
I just purchased a 15' fishing boat with Johnson 48 HP outboard. The thing sat for a couple of years. I drained the gas and replaced it. It starts and runs just fine (a little rough at idle, but acceptable).<br /><br />When I rev the idle throttle, the engine revs to high RPMs as it should. In the water, when I put it in reverse and nail it, it revs to high RPMs. Of course it does not go very fast in reverse, but the engine is revving properly.<br /><br />When I go forward (full throttle) the engine only revs to about half power. I can only go about 7-8 mph at full throttle. But it sounds like it is running ok. I took off the engine cover and observed that when doing this, the little arm that swings when throttle opens is swinging the appropriate distance, same as when I rev the idle<br />throttle. Yet, it behaves and runs as if I only have the throttle lever half way down.<br /> :mad: <br />What gives?
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 1995 Johnson 48 wierd

Confirm that the carb flaps are opening fully horizontal at full throttle setting.If so,by virtue of the fact that the engine set out of use for a couple of years,I'm guessing your carb fixed orifices and or porting are fouled with deposits and will need to be removed and cleaned.
 

Arachnid

Recruit
Thread starter
Joined
Aug 13, 2003
Messages
3
Re: 1995 Johnson 48 wierd

Thanks. Any idea why it would seem to rev correctly when in reverse?
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 1995 Johnson 48 wierd

Because the throttle cam does not actuate to full open in reverse.
 

Arachnid

Recruit
Thread starter
Joined
Aug 13, 2003
Messages
3
Re: 1995 Johnson 48 wierd

Thanks a million. I'll let you know what happens.
 
Top