1995 Johnson 28 SPL - excessive white smoke

kennedyx2

Recruit
Thread starter
Joined
Aug 2, 2016
Messages
3
Need some help understanding what causes this. From what I understand this motor doesn't have thru hub exhaust so under that assumption I realize that all the exhaust has to come out of the tubes. Im getting a little water spitting out the exhaust but a LOT of white smoke or steam. It just had a new head gasket, temp. sensor, and thermostat installed. I have ran it in the test pond and using a laser type thermometer under load its running about 160-ish and as soon I idle down it cools back down to around 140. The water coming out the "pee hole" is not scolding hot but is warm. Any ideas??
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
No your exhaust will also come out down by the prop when you are running faster or the idle is high. Where is the steam coming from.
 

ttankmoran

Seaman Apprentice
Joined
Mar 22, 2015
Messages
39
Have a 1996 version of the same engine, owned since new. This engine has always discharged a lot of steam from the two exhaust nostrils you speak of with only a fine mist of water. I chalk it up as normal, for whatever reason OMC set up the engine to discharge too much hot exhaust out the nostrils and/or not route enough water out those nostrils.

Have you just acquired this engine? Is this "problem" new? Or were you just expecting it to act a little different than it is?
 

kennedyx2

Recruit
Thread starter
Joined
Aug 2, 2016
Messages
3
I just aquired it through a trade. Never owned one this small and was curious if it was normal or a issue that needs resolving. If you say it's normal then I'm gonna motor on and keep a eye on the temp. Thanks for the info.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
might need to change out the impeller, just for full prepping. Over 160 is on the high side (140-160F is the standard range, but can run a little cooler). Lakes and ponds are a little warm this time of year, and that's a factor too. It sounds like you had a shop install the t.stat, so maybe some advice there about the water pump.
 
Last edited:
Top