1995 JOHNSON 25 HP, NO SPARK

dstein12

Cadet
Thread starter
Joined
May 8, 2017
Messages
7
I took starter & selenoid off to remove carb to clean it, put all back together, and now no spark. Is it possible i wired the selenoid wrong?
 

dstein12

Cadet
Thread starter
Joined
May 8, 2017
Messages
7
well now, after messing with the selenoid so much, I cant get it to work, think maybe i fried it! if I touch the positive cable to the starter cable the starter works, thats why i think the selenoid is fried. I should of left it how i had it wired originally, at least it worked, just no spark, so i guess ill replace it, so at least i can get it to turn over, then troubleshoot the spark issue. SMH. I also can not find an inline fuse on my motor.
 

jasper60103

Commander
Joined
Sep 18, 2008
Messages
2,055
well now, after messing with the selenoid so much, I cant get it to work, think maybe i fried it! if I touch the positive cable to the starter cable the starter works, thats why i think the selenoid is fried. I should of left it how i had it wired originally, at least it worked, just no spark, so i guess ill replace it, so at least i can get it to turn over, then troubleshoot the spark issue. SMH. I also can not find an inline fuse on my motor.

A few pictures of your setup would help to verify your wiring.
One terminal of the solenoid connects to +12V when the start button is pressed. The other terminal is grounded through the neutral safety switch.
So first, make sure its in neutral.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
selenoids are just coiled electro-magnets you should a low resistance with a ohmeter across the selenoid smaller posts

​ you should see open (infinite) across the big posts and 0 ohms when the selenoid is energized

you should hear it pull up if you apply +12 and grd across the small posts with 0 ohms across the fat posts when energized

if this works on its own then the neutral switch may be defective or wiring is defective


if it does click (pull up) and you do not see 0 ohms across the fat posts then the internal contact is not closing shut and the starter will not get it's feed of +12v to
run
 
Top