1995 90hp evinrude rebuilt

Dovester34

Recruit
Thread starter
Joined
Aug 16, 2017
Messages
1
Hey guys I've been a lurker for a while and I have learned so much from this. I finally registered to ask questions and to share what I can. I have a question about my rebuilt 95 90 hp evinrude. After I got my motor back from mechanic he explained the break in period. I have about 9 hours on it and I am still running double oil (1 pint of oil for every 6 gallons of gas while it is being oil injected) my mechanic told me I should be getting about 5700 rpm with a light load and about 5200 with medium/heavy load. With just me in boat (250lbs) bow mount trolling motor, a few fishing rods, and a small cooler I am only maxing out at 5100 RPM WOT. I am topping out at 30-32 mph SOG on my Garmin. At first I thought it was because it was wind/waves but yesterday I was out and the lake was glass with with winds at 5mph. My boat is an 1995 18 ft lund fisherman adventure and my prop is still a stock 14?19 aluminum prop. I seen some other posts about people getting up to 40mph in 18ft glass boats with same motor. My question is this just part of the break in period or is it because it is running rich? After motor is warmed up it also still will not start with out it being in neutral and at quarter throttle. My mechanic is on vacation so I cannot get a hold of him And thought I'd ask here.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
If your concerned don't run it til rebuilder has a chance to say something. Dont just assume wrench did bad and take a chance hurting something without giving the guy a chance.
 
Top