1994 Johnson 25hp - randomly sputtering

spagency

Recruit
Thread starter
Joined
Jun 10, 2018
Messages
4
The motor will run fine most of the time. However, sometimes when I turn it off to fish for a while, then restart it, it begins to sputter when I give it gas. It idles fine, it just won't accelerate. If I shut it off again and wait a few minutes, it usually fixes itself and runs fine again. Here it is sputtering - https://www.youtube.com/watch?v=qRTMb_DRx5U And here it's running fine - https://www.youtube.com/watch?v=luIhv9o6Nf8 Anybody have any idea of what's causing this? Thanks in advance!!

Scott
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
Your motor is exhibiting the effects of SLOW. Speed Limiting Overheat Warning. I did not hear a warning horn. Have you had any horns during any of these events? You do not have to experience an overheat to get SLOW. Have you by any chance changed spark plugs recently? Some plugs can cause RFI noise that put the engine into SLOW. The motor came with Champion QL77JC4 plugs. If you are sure your motor is not experiencing any overheat then you can unplug the sensor on the head. Brown wire up by the top spar plug. Put the lead from the wire harness away from the spark plug. Run the motor & see if the symptoms go away. You could just have a faulty sensor?
 

spagency

Recruit
Thread starter
Joined
Jun 10, 2018
Messages
4
Thanks, Rustywrench! I haven't heard any warning horns, but then again I didn't know there were any on this motor. I'll check the plugs and the sensor wire.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
When were the carbs cleaned last? It appears the engine is "loading up" (too rich) at slow speed and once cleared out it runs fine. Looking at the plugs would be the first and cheapest check.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Never seen warning horn on a tiller model.

Definitely dropping a cylinder when you try to accelerate. Some basic troubleshooting might be in order - pull a plug wire off, ground to block and run the motor. Note whether it stops entirely or if it stays running on one cylinder, then repeat with other plug wire off and grounded. Could just be a power pack going down.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Run with a timing light to see which cylinder is cutting in and out , has the miss.-----Perhaps test run with cowling off too.
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
Sorry guys, thinking about horn in tiller of 70TTL. Thought maybe they had added one on this model also? No horn as stated, but motor does have SLOW. Could be any of the things mentioned, but the coming & going is odd. QL plugs are good, but QL77JC4 are the recommended plugs. 82s are a little hot except for mostly trolling.
 

spagency

Recruit
Thread starter
Joined
Jun 10, 2018
Messages
4
Thanks for the help everybody. I'm going to put the QL77JC4 plugs in it and check the impeller just in case. Water is coming out okay, but not as strong a flow as I would like to see. It's probably time for me to swap it out anyway. If it is getting hot, I figure that's as good a place to start as any.
 
Top