1993 four winns fling engine replacement?

Status
Not open for further replies.

Vysion

Recruit
Thread starter
Joined
Jul 7, 2016
Messages
1
Found an adorable fling in nice shape on Craig's list. Previous owner stated:
Boat was running fine, except took on some water not that much, untill one day smelled an electrical fire shut her down and discharged the fire extinguisher into the engine compartment. So no fire but smoke and smell of burning pvc, so I'm thinkin, great I can handle electrical!

Needed a starter motor and some separation on some melted wires here and there, got spark back! but compression is low. Found the leak (fresh water plastic strainer had large crack in it). Guessing that she over heated, wrecked the engine? Hence low compression (50 to 82, which is actually up 10-13 per cylinder after doing the seafoam soak but don't really trust compression gauge cuz snow blower and lawn mower both in 69-75 range)

I do see fuel / oil leaking from port side heads. Found all the head bolts lose (like quarter turn or LESS past hand tight).

Here are my questions:
1) what should I do? Don't wanna spend good money after bad! want to believe the guy that sold it too me, met his wife and kids saw his new boat, but buyer beware!

Found an evenrude 115 in good running shape. How hard is it to swap power heads? Read the threads and one guy mentioned having to swap the crank shaft?

Should I pull the heads and have a look? Not really sure what to look for? Then wouldn't i need to have them machined? And the block too? I know a little about cars and nothing about 2 strokes, I don't really understand how the crank shaft is pressurized?

Should I bolt an outboard on the back of this think and remove the whole jet part? Only found one guy that tried that and sounds like the boat porpoises and cavitates
 
Status
Not open for further replies.
Top