1993 48hp ammeter erratic, idle fine, tach inoperable

pnadeau

Recruit
Thread starter
Joined
Aug 27, 2013
Messages
4
I have recently become the owner of a 1993 evinrude 48hp SPL. I recently took it out on the lake for a trial run; started and idled fine. ran at full throttle for a few minutes and then began to loose and regain power sporadically, the ammeter began to swing form 0 to 12 volts repeatedly. the tachometer is not working. I don't know if this is related to the current problem, or if it has been broken for some time. I would appreciate any advice as to what the probable cause is and how to trouble shoot this problem
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
Battery charging is done by the stator to the rectifier( a/c to d/c). go to CDI trouble shooting on how to test this system. The RPM fluctuation should not be related to the charging circuit, but more the power pack, charge coil, and coils, CDI also has trouble shooting for this system too, You will need a DVA voltmeter for some of this testing, Note: DVA adapters can be bought to make regular meters work. Also, looking at the parts diagram for your motor, your power pack is under the flywheel, if the power pack turns out to be bad there is a conversion kit available to get it out from under the flywheel(away from possible heat damage).
 

pnadeau

Recruit
Thread starter
Joined
Aug 27, 2013
Messages
4
Thank you, I will look up the troubleshooting steps at CDI and look into a DVA adapter.
 
Top