1992 Johnson 60 compression problems, what now?

mdp2146

Recruit
Thread starter
Joined
Jan 11, 2016
Messages
3
Hey everybody. Thanks for the information ya'll so free give on this forum!

I have a '92 Johnson 60 hp that I have been fighting with for the last 2 seasons. I've cleaned the carbs twice, replaced all fuel lines -on the motor and to the tank, replaced the gas tank, replaced the power pack, and finally replaced the fuel pump. I have not had a chance to put it in the water since replacing the power pack and fuel pump. However, reading on here the importance of checking compression helped me decide to check it before going any further. I'm sorry/glad I did.

My findings are as follows:
The top cylinder measured 25 psi
The middle cylinder measured 70 psi
The bottom cylinder measured 85 psi
These measurements were taken with all plugs out and the kill switch pulled. I measured them multiple times and they were very consistant.

So my question is, now what do I do? What are my options? Would this be gaskets, rings, piston damage?

I appreciate all of your help. I'm a do-it myself kind of guy but this is uncharted waters for me. Just wondering if I should give up and take it to a dealer.

Thanks again.

DP
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Pull the head and look, it could be many things, but most likely bad news. Taking the head off only takes a few minutes.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Fairly classic to throw parts at it instead of some trouble shooting.------Does the tell tale hose come off the side of the block or the top ?---------And yes you should remove the head to do an inspection.-----Lucky you if it is just the head gasket.
 

mdp2146

Recruit
Thread starter
Joined
Jan 11, 2016
Messages
3
Fairly classic to throw parts at it instead of some trouble shooting

Guilty as charged. I try not to do this but I'm no mechanic and most of the parts changed were via advice instead of proper homework.

I will try to pull the head tomorrow afternoon. I will post picutres of my findings. Hopefully I can get some more solid info here and actually get to the root cause of my issues.

I think the tell tale comes off the side of the block but I will verify that.

Thanks for the quick responses!
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There was a service bulletin that came out in 1994 to move the tell tale outlet to the top of the block.-It amazes me that there are still motors out there where this has not been done.
 

mdp2146

Recruit
Thread starter
Joined
Jan 11, 2016
Messages
3
Hey guys,

I just wanted to let you know I haven't had a chance to pull the head yet. I got a call Monday and looks like I will be working late all this week. Hopefully the weekend provides some time to dive into this. I've gotta get a move on. Fishing season is just around the corner!
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
There were 5/6 service bulletins related to this problem for this engine, after the rebuild do the bulletins.
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
.-It amazes me that there are still motors out there where this has not been done.
There are literary thousands of motors out there running without this mod and tattle location does not cause the engine failures. This mod came out as a infield fix for motor problem due to a specific boat design(partyhut).....
 
Top