1991 Johnson 60 thumping above 2000 rpm.

stevebrooks1983

Cadet
Thread starter
Joined
Jul 14, 2011
Messages
8
Just purchased 91 suntracker 18ft pontoon. Has 91 johnson 60 on it. This is my first hooray into boating and already having problems. First I had trouble starting the boat. What is the best way to start the boat? Not quite sure on the choke with the key arrangement and how it works. Once I got the boat started I throttled up and it stalled a couple times. Finally it ran smooth and about 10 minutes later it felt like I was hitting stumps in the water. The motor would jump or thump. The motor sounded fine just like something slipping. After this, I ran the motor below 2000 rpm and there was no thumbing, but anything above 2000 it would thump about every 8 seconds. Any information would be great. Thank you.
 

Monte1961

Lieutenant Junior Grade
Joined
May 8, 2011
Messages
1,180
Re: 1991 Johnson 60 thumping above 2000 rpm.

Push key in will cause choke to engage. Turn key to on position, now push it in an you should hear it click. Next you will want to scribe a line on prop hub and prop. Take for a quick spin and see if scribe lines still match up! If they arn't, hub worn out. Replace with new hub or new prop. Hint new prop will already have new hub. Welcome to iboats and post back results!
 

stevebrooks1983

Cadet
Thread starter
Joined
Jul 14, 2011
Messages
8
Re: 1991 Johnson 60 thumping above 2000 rpm.

I just took it to a local marina. I watched the guy and had about a 90 min conversation with him. He showed me that the shaft on prop was bent also said i need to rebuild carbs. He also said that the Dog Clutch gear was worn and causing it to thump. He is not the owner of the shop. He recommened to replace the lower unit instead of replacing gears. He has a used one there that he said installed for $500. I told him $600 for carbs and lower unit installed. What do you think?
 

Dave Brick

Seaman
Joined
Jul 14, 2010
Messages
63
Re: 1991 Johnson 60 thumping above 2000 rpm.

I have a '92 60 hp that I assume is pretty similar. I bought it completely rebuilt by a reputable shop, and have been very happy with it. Did the guy at the shop agree to your offer? If that is all it needs, I'd say it is a fair price.

Have the shop check compression before they start, make sure you aren't throwing good money after bad.
 

stevebrooks1983

Cadet
Thread starter
Joined
Jul 14, 2011
Messages
8
Re: 1991 Johnson 60 thumping above 2000 rpm.

Just Found out all the info in 91 Johnson 60. I Need a new lower unit and carbs rebuilt. $1100 for everything does this sound like a fair price?
 

Monte1961

Lieutenant Junior Grade
Joined
May 8, 2011
Messages
1,180
Re: 1991 Johnson 60 thumping above 2000 rpm.

if you wanna spend the money thats your business. If you wanna do the work yourself and save some money thats our business. Marine and boat repair labor is about $ 75.00 to $110.00 dollars per labor hour! You can most likely find a good lower unit for $200.00 and carb kits for $18 or so dollars a piece. You can do the math. Good luck and post results! Monte1961.
 
Top