1991 Johnson 25hp outboard cooling issues

JB9339

Recruit
Thread starter
Joined
Oct 24, 2017
Messages
1
I've got a 1991-2 Johnson 25 HP outboard that had no tell tale output, I've replaced the entire water pump, and checked that the tell tale hose and fitting are clear. What is the next thing that I should examine to see if/where there is a blockage?

Thanks
JB
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Remove lower, back flush in t-stat housing and out water tube.

When reinstalling lower make sure water tube gets into grommet on pump housing. These can be really tricky for some. I use a small string looped around hose to help align then pull it out as the lower slides home.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Are you testing in a bucket? The water level MUST be a few inches above the seam between the exhaust housing and gear foot.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
+1 on manual flushing, as suggested -- also running with the l.u. deep in a barrel (half way up the leg is a decent rule, I think.

Try some weed whacker line run deep into the tell tale -- see if that helps (bugs/spiders/mud wasps....)

[Edit. but check to be sure it's operating in the proper temp range, just in case....]
 
Last edited:
Top