1991 evinrude not running under load

buddha

Recruit
Thread starter
Joined
Jul 19, 2003
Messages
2
I have a 1991 evinrude 70hp. It sat up for awhile so i think some trash got in the carbs. I removed and cleaned the carbs. Put them back on and ran them in the yard in gear and it ran fine. Took it to the boat landing, put in the water and cranked it up ran at idle fine but under load cut out. Now will not run right any suggestions on the problem or where to find out what is wrong. It almost acts like it is out of time or a carb problem. Please help new to working on boat motors want to learn real bad. :confused: :confused: :mad:
 

LarrynBama

Recruit
Joined
Jul 19, 2003
Messages
2
Re: 1991 evinrude not running under load

I have a 60hp 1989 evinrude that was doing the same thing....I found a few things that was suspious of the ailment....when I pulled and cleaned my carbs I used air prssure to blow out the ports....found a chunk of rubber from the vacume line in the 2 carb....next I found several reeds valves not closing all the way....I fliped then over...also I had a pinched wire in my wire bundle engine houseing case....where the bundle is clamped down....check it close....I thought I did...I also changed my plugs....and took 2 fuel samples to ensure I hadnt let water get into my fuel system....good luck...let me know what you find.
 

buddha

Recruit
Thread starter
Joined
Jul 19, 2003
Messages
2
Re: 1991 evinrude not running under load

larrynbama, I took the number one carb off today to see if it had clogged back up. It didn't appear to be dirty, but I have not taken the other two off yet. I did find some rubber in the float needle. I will get back to you soon. Thanks for responding, it has given me something else to look for now.
 

LarrynBama

Recruit
Joined
Jul 19, 2003
Messages
2
Re: 1991 evinrude not running under load

Thats a big find.....make sure you blow the ports out with air pressure,and you can feel air escaping through the ports...it would be a good thing to change your fuel and vacum line....the rubber getting into your carb is an indicator....also if you find rubber in one carb you can be sure some is getting in the other 2.<br />You want to make sure you remove your jets and blow those ports out also, good luck, let me know the outcome.
 
Top