1991 Evinrude 30hp Prop

jsmilesTX

Recruit
Thread starter
Joined
Mar 23, 2018
Messages
3
Hello,
last time I posted on this page I was able to get my problem resolved.

here is my current issue.

my prop has a lot of play (forward and backward) all parts seem to be there after looking at skimatics. My question is how would I know if this is the correct prop on my motor? I bought the boat in November.

The prop has these numbers on it
10-3/8x13

the boat has no acceleration, how ever the prop does seem beat up a little. I also feel there is a lack of top speed.

Any advise on how to diagnose the loose prop and the prop size would be very much appreciated
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
http://ww2.iboats.com/Gearcase/dm/ca...iew_id.1548120

thrust washer and prop nut washer, according to the diagram. There are two or three aluminum props (could go to a smaller diameter but higher pitch.) Your current prop is one of the standard ones.

Is the motor in excellent running shape — measured spark and compression? Fuel or carb issues, potentially? If the engine has high revs but no thrust, could be a spun hub. Additionally, some hulls (actually probably all of them) are sensitive to load and distribution. Finally, water logged foam under the floor will slow you down big time.

Lot’s of possibilities..
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Without knowing what kind of boat it is on, it is difficult to know whether or not your engine is performing up to expectations. Also as mentioned earlier, what condition is the engine in? Good compression, spark at both cylinders, carb opening fully. and proper spark advance will affect how the engine performs
 
Top