Hello Gents,
Looking for some assistance...my power tilt and trim has been working a little slow lately..pulled the boat for the storm and put her back in last night..she tilted up in the driveway, but a little slow...tilted down at the ramp and up at little to sneak over the mud due to the blow out tide..engine would not tilt back down..tide her up and now it will not do anything.....the binacle control switch is activating the selenoids.they are clicking away and I even tried jumping across the terminals with no response...I checked voltage and cleaned the terminals..all good. Checked the selenoids with an ohm meter and they tested OK...read the service manual last night and it said to put voltage to the blue and black wires...hooked up a battery charger and put the clips on the wire ends and nothing..not even a spark from the clips.....looked online and a new pump motor is 900-1000...so I am looking for suggestions.....thanks!
Looking for some assistance...my power tilt and trim has been working a little slow lately..pulled the boat for the storm and put her back in last night..she tilted up in the driveway, but a little slow...tilted down at the ramp and up at little to sneak over the mud due to the blow out tide..engine would not tilt back down..tide her up and now it will not do anything.....the binacle control switch is activating the selenoids.they are clicking away and I even tried jumping across the terminals with no response...I checked voltage and cleaned the terminals..all good. Checked the selenoids with an ohm meter and they tested OK...read the service manual last night and it said to put voltage to the blue and black wires...hooked up a battery charger and put the clips on the wire ends and nothing..not even a spark from the clips.....looked online and a new pump motor is 900-1000...so I am looking for suggestions.....thanks!