1990 Johnson 115 VRO Problem??

jwarner

Recruit
Thread starter
Joined
Jul 7, 2003
Messages
2
I launched my boat last weekend. Pumped both oil and fuel bulbs prior to starting the engine.Give it full throttle and went about 1/2 mile. The engine started fluttering and finally died. I checked the pressure of the fuel bulb and it was limp. Pumped it up again but the engine wouldn't start. I let it sit for about an hour, engine started long enough to get it out of the water. Could this be the VRO pump going out? I had a top end overhaul done back in 1997. Both carbs were rebuilt and syncronized. New fuel filter was installed last year. Gas and oil were fresh. Any suggestions?
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 1990 Johnson 115 VRO Problem??

A limp fuel bulb is indicative of a fuel restriction up stream of the bulb.Tank pickup tube,anti syphon valve on tank fitting,tank not venting properly,or defective primer bulb.<br /><br />Unless you have disconnected the oil lines there is no need to reprime the oil line each time .If you do reprime the oil line it should always be primed before you pump the fuel primer bulb.
 

jwarner

Recruit
Thread starter
Joined
Jul 7, 2003
Messages
2
Re: 1990 Johnson 115 VRO Problem??

So, if I replace the vent hose and all of the fuel lines from the tank to the external engine, this should solve my problem correct?
 

knights

Cadet
Joined
Jul 8, 2003
Messages
19
Re: 1990 Johnson 115 VRO Problem??

Open caps to both first, the vents may plugged, the breather inlets could be blocked, then check lines. So many options.
 
Top