1990 Evinrude 25hp Misfire issue

donnyrogers123

Cadet
Thread starter
Joined
May 29, 2016
Messages
8
Model TE25ELSE

I am having a misfire that is driving me nuts trying to get to the bottom of it . A little history on the motor it was last ran about 10 years ago and parked for a stalling issue and was drained and sealed up and recently given to me. Motor starts and idles with a slight miss here and there and when u throttle up it misses and backfires a bit and shakes a lot. I had done some troubleshooting and am at a loss for what else to try. This is a UFI engine under flywheel Ignition and I have had the flywheel off to check items under and everything looked good key was not sheared before and miss was there before I took it apart. So far items I have had to replace were power pack trigger got hit by flywheel bolt was loose put new oem champion spark plugs gapped to .040 checked coil packs using a multimeter and got 263 off lead wire peg to ground for both checked warm compression and cold compression both are within 1 of each other warm being 117 each fuel mixture is 100:1 tried to adjust low mixture screw in carb out 1 ? and the miss continues I have read that this timing is correct as long as key isn?t sheared the only thing I had left is plug wires witch I have on order but tried some other ones and still had same issue. Sorry for the long paragraph but I am at wits end with this miss and cant figure it out I also after running with new plugs found one is wet and the other one looks carbon covered Thanks!
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Agree with fuel mix above. They changed away from the 1% a long time ago.

Have you tried a spark checker that lets you test both ay once so you can see the alternating spark?
 

donnyrogers123

Cadet
Thread starter
Joined
May 29, 2016
Messages
8
Thanks for the fuel suggestion i am newer to this motor and just went off manual as far as spark i have a inline spark tester everything looks ok and spark jumps a large gap with a nice blue spark with my clip on tester am i right when i say timing should be fixed?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Start with a compression test.------Then post a picture of the adjustable stop on the throttle rod.---Take a picture with it at the slowest idle position.
 

donnyrogers123

Cadet
Thread starter
Joined
May 29, 2016
Messages
8
No Title

To jake these were the plugs i replaced like a week ago and gapped to .040 from my evinrude owners manual havent tried to reduce gap to .030 will try tomorrow

Racerone i did compression test got 117 on both warm test as far as pics im not very familiar with this motor im very mechanical but marine is newer to me i took some pics of the throttle linkage do u mean the roller on the advance?
 

Attachments

  • photo247856.jpg
    photo247856.jpg
    369.6 KB · Views: 2

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There is a thin metal rod that goes to the back of the motor.--It has a stop at the back end.
 
Top