So I'm new to the forum so I'll try and give a quick diagnosis and explain as best I can, but I think the pictures will explain it better. When ever I go to trim the engine down it sucks in the right trim ram, then once it's fully in it starts sucking in the left trim ram, then once that's fully in the tilt finally starts to go down, but then when the tilt gets halfway down, it starts pushing out the right trim ram and then the left ram and then it goes down like it normally would till it bottoms out. (Side note) when i start to tilt it down with the switch I can push the motor down just a little bit until it hits a fluid pressure then I hit the switch again for a second and I can push it down again.