1989 Johnson 50hp TJ50TLCEC problems at wot

a_will84

Recruit
Thread starter
Joined
May 26, 2016
Messages
3
I purchased my 1989 Johnson 50hp outboard as is. Cranks and runs great on ears. Checked compression and it's great both cylinders only one pound difference. Took it out and would only run what seemed to be half speed. Won't plane out my 15 ft aluminum boat. Took it home cleaned and rebuilt the carbs. Took it back out with no change. Now where do I look? Not sure what to do next. It is firing on both plugs also. I'm thinking maybe out of adjustment maybe timing. Please help
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
try pushing key in while having problem, if engine starts to go good, high speed jet may need looking at, also do you have a tach, what rpm's is it turning
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Throttle cable adjusted properly??? If the throttle butterfly in each carb is not opening fully then the cable needs adjusting and it probably needs "link&sync" as well. You need a service manual for that procedure.
 

a_will84

Recruit
Thread starter
Joined
May 26, 2016
Messages
3
Update. Took it out today to test. Got the control cables adjusted right and put a timing light on it and got it close but I have now figured out a little more. I pulled both plug wires while running and had no change in operation when I pulled the top plug wire but it died when I removed the bottom one. Check the carb bowl on the top and it was full. Now next question. What do I do now? Go back through the top carb again? What will make it pretty much not work period? I thought I cleaned and rebuilt it good.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Open air gap spark test. Holding the plug to the head tells you nothing. I am assuming you will find good spark on one and not the other. If that is the case get yourself an ohmmeter and a DVA and someone here will talk you through it. Or go to cdi website and use their trouble shooting guide.
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
when you pulled the plug wires you did a "drop test", your only running on one cylinder, as jakedaawg says start electrical tests, you might find a manual online
also , this maybe jumping ahead, but if you've got the tools, remove flywheel to see if dark sticky goo has drained from charge coil or trigger sensor.
 

a_will84

Recruit
Thread starter
Joined
May 26, 2016
Messages
3
Update. Last night I put a timing light on it and put it to wot and it wasn't staying consistent on 19? . So it appears I'm misfiring at wot and have a bad power/coil pack.
 
Top