1989 Johnson 150hp midrange low power

mark's Mobile marine

Cadet
Thread starter
Joined
May 14, 2017
Messages
6
I am working on a friends 1989 johnson 150 xp. After he bought the boat we had intermittent no start issues. Turned out to be a bad trigger. Replaced with CDI trigger and replaced power pack with CDI one. Motor runs good, Good Idle, Nice WOT. but he has to push in on choke to get her out of the hole and on to plane. Of course i have clean carbs. we switched to Premix and remove VRO pump. Last year we tore down the motor AND replaced all gaskets and cylinders look good. Compression is 95 - 100 psi on all cylinders. did all the sync and link. Everything seems find but still need to choke to get on plane. is it possible i need to change the jet size? we are at 500ft over sea level. problem has been consistant since he bought it ever after repairs and adjustments.

Any ideas?
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
500 ft wouldn't be an issue, but it will run richer as you gain elevation, so it's going in the right direction already, and if anything the elevation would make it run ever so slightly better.

​Clean the carbs again and make sure the sync is correct, jet size would only be masking the actual problem (if it worked at all), and then if you cleaned the carb and got it right the jets would need to be changed back.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Make sure you cleaned all the orifices. Ifor this is a crossbow I think there are four in each? Tow lows and two highs in each of the three carbs.

Do a cylinder drop test at idle or off idle in gear. That will give you an idea of which one is messing up.

When you deleted the vro you switched to two pulse pumps?

Also make sure your transition and off-idle circuit in the carbs are clean.

Then there is the synch and link. Transition issues can be found if your not starting to advance timing before throttle plates begin to move.
 

mark's Mobile marine

Cadet
Thread starter
Joined
May 14, 2017
Messages
6
I have had the carbs off and cleaned in ultra sonic tank 3 times. adjusted floats. ect. i am pretty sure all is clean. I have done sync and link and set pick-up timing to 7 degrees. the most recent run showed No. one cylinder spark plug a little drier then the rest of the plugs. I have not had a lot of experience "reading" spark plugs. Is this a concern? I switch the VRO to pre mix and an Electric fuel pump mounted in the transom of the boat. None of the above repairs or changes seems to have effected this issue. of course these carbs do not have adjustable mixture screws though i do not now if that would help either since its idle is pretty smooth.
I will try the cylinder drop test and post later. Keep it coming guys, Great advice, Thanks
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Electric fuel pumps aren't that popular due to the safety issues created if they're not installed correctly, the stock type fuel pumps work very well and are cheap to rebuild.

​You can run the motor with the carb cover off and put your hand over each carb while it's bogging to see if it's just one cylinder acting up, or more than one. It will run slightly richer with your hand partially blocking the carb throat.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Ultra sonic cleaner is fine to loosen stuff up but you still need to remove orifices and spray though those and all the passages.
 
Top