1989 Evinrude Cooling On Starboard Side.

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
My issue is overheating on starboard side of engine. Left side runs cool. This engine is running at idle and heats up right away. Changed Thermostats springs and poppets. Still same issue. I disconnect hoses at heads , water flowing and cools just fine. Going to try to upload a video. I'm stuck.Evinrude 100 Sorry.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Is the hole in the middle of the thermostat housing unblocked?
I widen it when i get my hands on one of these
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Yeah. Have you checked that your telltale works and isnt blocked?
You have the thermostats so the body is to the stern and the head is facing forward?
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
Yes Sir. Stats are in right. And telltale flows nice. When right side heats up I disconnect right water hose at head port and cools right down ...Hook it back up while running and heats back up again.
 

iggyw1

Ensign
Joined
Oct 24, 2011
Messages
974
Yes Sir. Stats are in right. And telltale flows nice. When right side heats up I disconnect right water hose at head port and cools right down ...Hook it back up while running and heats back up again.


Sounds like the water jacket is plugged up on the right. Try to backwash it with some water pressure to blow some chunks out of it. Maybe pieces of an old water impeller??
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
Almost seems that there is not enough pressure to open popetts if they're supposed to open. Not sure on that. Stats are new and so are popetts and springs. I even pan tested stats to make sure didn't have a bad one. Trouble is the right side heated up initially so assumed the problem was in the stats. Ordered a shop manual ...Let me ask this...What should head temps be? I have Lazer gun to check . Right side really hot to touch within a minute or so and left side nice and cool
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
Ok. I'll try backflushing. Makes sense. Is it possible to clean water jackets with vinegar or something similar?
 

Fed

Commander
Joined
Apr 1, 2010
Messages
2,457
It does sound like the starboard thermostat is not opening, it needs to let the cold water out through the little holes mentioned above so the hot water can get from the heads into the thermostat housing and activate the thermostats, of course once the thermostats start to open then plenty of hot water gets to them.
A big pain I know but I'd revisit the little holes because it runs cool with the hose removed.
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
That's next... Never have bought used... Suspecting impeller. Doing compression test as well tomorrow. I will keep in touch. Thank You Guys So Much... It's getting narrowed down. Again..Thanks!!!
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
Sorry ... Meaning never have changed impeller.. I bought this boat used....Ran great at first ..No issues... I'll find it with your help ... I'm getting close!! Again thanks!!! Happy Boating!!
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
I dropped lower end to change water pump which is on order. I hooked garden hose to water tube to test water flow and noticed water coming back down thru from above at power head where water tube goes too. Is that normal??
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
I dropped lower end to change water pump which is on order. I hooked garden hose to water tube to test water flow and noticed water coming back down thru from above at power head where water tube goes too. Is that normal??
Depends where up there exactly
 

Chevelle74

Cadet
Thread starter
Joined
Sep 13, 2016
Messages
19
Water Pump Did The Trick So Far ... We'll See When I Get It On The Water. Also Drilled The Air Bleed Larger On Thermostat Manifold . Running Cool Now!!! Thank You Sir For All Your Help!! Appreciate It!!!
 
Top