1989 evinrude 90hp v4 destroyed piston

Rustoleum82

Recruit
Thread starter
Joined
Jul 5, 2016
Messages
1
I have a 89 model evinrude 90hp v4. It's the original motor on a stratos 266fs. Last week it began to run extremely rough and would cut off after a hard run. I nursed it into the dock and began to pull the spark plugs. When I removed the top left cylinder spark plug it had metal chunks all over it. When I got home I pulled the head and the piston literally has a chunk taken out of it almost as if the top of it hit something while it was running. I tried to upload some pictures but it would not allow it. The cylinder walls are pretty scored up. My question is are these motors sleeved and is it possibke to just put in a new sleeve and piston. When it comes to outboards I'm not really good with them so any help be appreciated thanks.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Post your pic on Photobucket and link it. Depending on the damage, a re-bore of the one cylinder and a single oversize piston (of the same make as OE) can be used. The rest of the pistons should be re-ringed and their bores honed for best results since you have to split the crank case and send it to the machine shop anyway.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
In my opinion every one of these " crossflow " motors is going to suffer the same failure.---See it all the time.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
And while you have it apart, make sure the rubber water diverters in the block are in good shape. Replace if they're squished or swolen.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Unless you plan to rebuild the entire motor don't bother working on it, the other Pistons will suffer the same fate before long. And I'm not sure putting that much money into it would be worth it.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
If you can do the labor yourself you can do it for about $1200-1300 The WSM kits are good I highly recommend upgrading to Wiseco pistons not the WSMs as they have the ring design that caused the problem in the first place.
 
Last edited:

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
If the rest of the motor is in good shape, it's a lot better to spend the $1200-1300 noted to get another 25 years out of it. Beats the heck out of spending $12k or more re-powering - you can buy a lot of fuel for $11,000.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
If you like the motor and would like to keep it, a rebuild would be OK, you'll probably end up with new eletronics and then rebuilding the lower unit before too long, plus ongoing nickel and dime stuff. That design started life around 1960, so it's not exactly current technology. I had the 1998 version of your exact motor, it died the same way, after pulling the head I stopped doing anything to it got rid of it. I picked up a 2005 Merc 90 for about $2,000 and never looked back, a several decades newer design makes a huge difference, go figure. (This was about 4 years ago)
 
Top